Multiwfn forum
Multiwfn official website: http://www.shanxitv.org/multiwfn. Multiwfn forum in Chinese: http://bbs.keinsci.com/wfn. E-mail of admin: sobereva[at]sina.com
You are not logged in.
- Topics: Active | Unanswered
#1 2021-05-30 15:56:34
- Arshak
- Member
- Registered: 2021-05-30
- Posts: 2
Closed Multiwfn during delta_r index calculation
Dear colleagues,
I found some problems with electron excitation analysis especially with calculations of delta_r index and lambda index.
When the index of the excited states that I want to calculate delta_r index is inputted, the program immediately closed without giving the results.
Does anybody find the same issue or know how to perform the mention calculations?
Thanks in advance.
Offline
#2 2021-05-30 20:58:58
Re: Closed Multiwfn during delta_r index calculation
Probably there is a problem in your input file, or the format of your input files is incompatible with this function.
Please upload your input file; if the file is too large even after compression, please send the file to my E-mail.
Offline
#3 2021-05-31 20:07:55
- Arshak
- Member
- Registered: 2021-05-30
- Posts: 2
Re: Closed Multiwfn during delta_r index calculation
I used the Gaussian09 output files *.log. In the route section I specified following: #t b3lyp/gen pseudo=read td=(nstates=80) pop=full gfinput iop(9/40=2) scrf=(solvent=toluene) scf=(maxcycle=250) IOp(3/76=1000001500) IOp(3/77=0720008000) IOp(3/78=0810010000).
Multiwfn successfully loaded the output files, but when I inputted the indexes of the excited states that you want to calculate delta_r, they immediately closed. The same happened when I loaded the calculation results with more simple route section: # b3lyp/gen pseudo=read td=(nstates=80) scrf=(solvent=toluene) scf=(maxcycle=250) IOp(3/76=1000001500) IOp(3/77=0720008000) IOp(3/78=0810010000).
The output file successfully was opening and calculating two years ago but now it does not do the same calculations with new and old files.
I sent the log files to the admin email and will be appreciated for helping with this issue.
Offline
#4 2021-05-31 20:48:05
Re: Closed Multiwfn during delta_r index calculation
After booting up Multiwfn, you should load .fch file first, and then after entering the function for calculating delta_r, input the path of out/log file. Please try to reproduce the example of evaluating delta-r in Section 4.18.4 of Multiwfn manual first.
In addition, iop(9/40=2) is not adequate. In order to obtain relatively accurate delta-r, you should use at least iop(9/40=3).
Offline