Multiwfn forum
Multiwfn official website: http://www.shanxitv.org/multiwfn. Multiwfn forum in Chinese: http://bbs.keinsci.com/wfn. E-mail of admin: sobereva[at]sina.com
You are not logged in.
- Topics: Active | Unanswered
#1 2021-08-28 12:51:46
- sahop
- Member
- Registered: 2021-08-28
- Posts: 3
perform NCI just for intermolecular interactions using multiwfn
Hi
I am trying to perform the NCI for some molecules. but in the final image become too crowded. Is it possible to clean the image from the intramolecular surfaces?
Offline
#2 2021-08-28 16:27:59
Re: perform NCI just for intermolecular interactions using multiwfn
It is strongly suggested to use IGM (independent gradient model) or IGMH (IGM based on Hirshfeld partition), in these analyses you can only visualize interactions between two or more specific fragments, and hence isosurfaces corresponding to intramolecular interactions can be completely avoided. See Section 3.23.5 and Section 3.23.6 for introduction of IGM and IGMH, respectively. Also see Section 4.20.10 and Section 4.20.11 for their examples.
IGMH has evidently better graphical effect than IGM and it is dependent of wavefunction (like NCI), while IGM is cheaper and only requires structure information (like promolecular NCI).
Offline